Subject	That's a LOT of lapping
Posted by	BlackholeZ on March 23, 2013 at 4:25 PM
	This message has been viewed 163 times.
In Reply To	that can be fixed with a lapping block posted by aliaZ on March 23, 2013 at 08:47 AM
Message	OP, take that shit back, they might try some bullshit like "well you didn't specify" but tell them to go pound rocks. They know better and were just trying to get it doen quick. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Machine Shop Block Decked. COMMENTS PLEASE - itlnstln13 20:57:39 03/22/13 Looks rough to me! (n/m) - SammybTT(TN) 21:10:35 03/22/13 I agree, it looks like they needed to slow down the feed - zellamay 21:56:56 03/22/13 yikes!! what did they use a fly cutter?... lol (n/m) - Zvil (FL) 22:16:13 03/22/13 Re: Machine Shop Block Decked. COMMENTS PLEASE - itlnstln13 23:01:41 03/22/13 hi res - Dane (Houston) 23:29:37 03/22/13 That is unacceptable! Better get that smoother or - JMartz 13:31:23 03/23/13 Re: Machine Shop Block Decked. COMMENTS PLEASE - itlnstln13 23:39:53 03/22/13 that can be fixed with a lapping block - aliaZ 08:47:05 03/23/13 That's a LOT of lapping - BlackholeZ 16:25:00 03/23/13 and hope that they don't screw it up worse than it is (n/m) - aliaZ 06:14:00 03/25/13 Anyone have a 1996 Engine Block torn down? Serial Number?? - itlnstln13 00:02:03 03/24/13 Never mind about Serial Number. - itlnstln13 00:13:46 03/24/13 Regardless of what you see with the others that machining>> - ZUL8TR 09:43:02 03/24/13 have them fix it or take it somewhere else. (n/m) - nemo1080 (Iowa) 14:31:49 03/27/13 . - ZiNnYc 14:57:40 03/27/13
Post a Followup	You cannot reply to this message because you are not logged in.