Subject	Hi, I'm a little bit lost on this....
Posted by	Medallion Man on March 21, 2013 at 1:02 PM
	This message has been viewed 152 times.
In Reply To	Tensioner not set properly posted by ChrisMedaris on March 21, 2013 at 12:48 PM
Message	I can't see where you have said that the timing is getting worse... I can only see that the CAS was adjusted too far in the first place and now playing with it doesn't make it any getter and it has to be were it was at first. So to me it looks like the timing was wrong in the first place by a couple of teeth... and still is. it needs to be done again and counted not just go off the marks on the back plates (that can move).
Follow Ups	Ok, so my timing belt is "off"...........options? - LJZTT 10:47:00 03/21/13 food for thought - Zvil (FL) 11:05:58 03/21/13 you didnt read the post did you? (n/m) - LJZTT 11:42:18 03/21/13 lol yes I did - Zvil (FL) 11:59:26 03/21/13 explain how the timing belt can drift after a fresh 120k? - LJZTT 12:39:01 03/21/13 Tensioner not set properly - ChrisMedaris 12:48:13 03/21/13 anything else? - LJZTT 12:59:08 03/21/13 you can put the belt on with all the marks lining up and - ChrisMedaris 13:02:54 03/21/13 do I remember step by step what I did and didnt do - LJZTT 13:23:50 03/21/13 Hi, I'm a little bit lost on this.... - Medallion Man 13:02:25 03/21/13 I cant remember where the CAS was at immediately after - LJZTT 13:28:20 03/21/13 FYI (for future) PTU loop = +10 more degrees of advance - evan_aggie 00:21:55 03/22/13 I am aware of 5 causes to the timing drift - Zvil (FL) 13:34:50 03/21/13 then timing belt jumps should always result in timing that - LJZTT 18:21:54 03/21/13 skipping T-belt will only advance the timing - Zvil (FL) 20:38:14 03/21/13 then this cant be my problem - LJZTT 13:25:27 03/22/13 Have you removed the CAS and looked at the teeth for wear? - Woody75 (Denver) 15:44:39 03/21/13 yes, I remembered your post where you came across this - LJZTT 18:18:32 03/21/13 Just something to think about ... - Xteam300TT (South Tx ) 22:17:57 03/21/13 *this* (n/m) - evan_aggie 10:41:39 03/22/13 car runs like absolute crap with CAs in middle - LJZTT 13:27:22 03/22/13 No, it won't cause damage. - TriniTT 11:30:59 03/22/13 update........ - LJZTT 13:31:14 03/22/13 There IS only one way for the CAS to go on - Zvil (FL) 16:03:12 03/22/13 Once you check timing with a light and teeth count>> - ZUL8TR 10:09:29 03/24/13
Post a Followup	You cannot reply to this message because you are not logged in.