Subject	I got a pack of resistors from radio shack a while back
Posted by	BlackholeZ on March 12, 2013 at 12:56 AM
	This message has been viewed 123 times.
In Reply To	I replaced both the sensor and sub harness when I rebuilt my posted by SammybTT(TN) on March 11, 2013 at 09:12 PM
Message	I think they are 1k. I need to look up the faq, maybe the pack I have was from another project. I did plug a resistor straight into the connector, and am still getting code 34. I think I have determined that I connected the subharness to the wrong pin on the knock sensor. I am getting no resistance to ground. It was pretty late when I did this, and I'm rather pissed that it didn't go as well as I hoped. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Replaced Knock sensor, still code 34 - BlackholeZ 17:23:58 03/11/13 you may have a fault in your harness - aliaZ 18:47:51 03/11/13 I am getting good continuity on the sensor - BlackholeZ 19:39:00 03/11/13 I replaced both the sensor and sub harness when I rebuilt my - SammybTT(TN) 21:12:32 03/11/13 I got a pack of resistors from radio shack a while back - BlackholeZ 00:56:36 03/12/13 The engine harness has resistance as well - Zvil (FL) 11:37:36 03/12/13 Yeah, I had the wrong value resistor - BlackholeZ 02:43:03 03/14/13
Post a Followup	You cannot reply to this message because you are not logged in.