Subject	I am getting good continuity on the sensor
Posted by	BlackholeZ on March 11, 2013 at 7:39 PM
	This message has been viewed 119 times.
In Reply To	you may have a fault in your harness posted by aliaZ on March 11, 2013 at 06:47 PM
Message	In fact too good. I may have gotten the ground pin instead of signal. It was pretty late. I had the resistor trick before I did this and had no problem, now I can't even get rid of the code with a resistor... -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Replaced Knock sensor, still code 34 - BlackholeZ 17:23:58 03/11/13 you may have a fault in your harness - aliaZ 18:47:51 03/11/13 I am getting good continuity on the sensor - BlackholeZ 19:39:00 03/11/13 I replaced both the sensor and sub harness when I rebuilt my - SammybTT(TN) 21:12:32 03/11/13 I got a pack of resistors from radio shack a while back - BlackholeZ 00:56:36 03/12/13 The engine harness has resistance as well - Zvil (FL) 11:37:36 03/12/13 Yeah, I had the wrong value resistor - BlackholeZ 02:43:03 03/14/13
Post a Followup	You cannot reply to this message because you are not logged in.