Subject	They don't
Posted by	BlackholeZ on March 11, 2013 at 12:36 PM
	This message has been viewed 112 times.
In Reply To	The wastegate holes look like they match posted by Zvil (FL) on March 11, 2013 at 06:49 AM
Message	When clocked properly so that the outlet clears the exhaust manifold, the wastegate actuator arm is jammed sideways in the hole in the bottom of the actuator. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Different compressor housings? - BlackholeZ 23:55:34 03/10/13 The wastegate holes look like they match - Zvil (FL) 06:49:01 03/11/13 They don't - BlackholeZ 12:36:17 03/11/13 Is one from an auto, or is that only exhaust housings? (n/m) - johnnysombrero 10:48:17 03/11/13 the compressor side is the same on all stock turbos - Zvil (FL) 11:35:28 03/11/13 but the hole pattern for the heat shield and wastegate - BlackholeZ 17:14:26 03/11/13 for clarification, the one that fit right is on the left (n/m) - BlackholeZ 12:37:18 03/11/13 Ok I failed, I forgot the holes with the larger space - Zvil (FL) 15:59:03 03/13/13
Post a Followup	You cannot reply to this message because you are not logged in.