Subject	check your timing
Posted by	Zvil (FL) on March 05, 2013 at 9:00 PM
	This message has been viewed 345 times.
In Reply To	At 3500 to 4800 rpms my Z jerks and stumbles very bad posted by z32z on March 05, 2013 at 07:12 PM
Message	Make sure the ignition timing is steady I would also check the timing belt and gears to verify everything is on time and didn't jump a tooth Did this start happening out of no-where or did you change something recently and the problem showed up? Maybe see if the problem changes or goes away when you unplug the vtc solenoids *disclaimer*: all that I say may be true or I may be completely wrong and I accept that.... please, it is your duty as another person on the internet to in-politely tell me how wrong I am :) "The dreaded 2nd windshiled wiper swipe when you turn it off its almost like tis showing you that it's boss, and it doesn't have to stop when you tell it to :("-College Boy (discussion on ptu relocation) "No good reason to put it there anyway. -Bernie (NoVA) False -vorpalZ False. -Bernie (NoVA) You're correct, there are 3 good reasons -vorpalZ False. -Bernie (NoVA) Wow, right again, just remembered another, make that 4 -vorpalZ" XD
Follow Ups	At 3500 to 4800 rpms my Z jerks and stumbles very bad - z32z 19:12:03 03/05/13 Mass Air Flow Sensor? Oxygen Sensor? Coil Packs? - Summeronthechain (MN) 20:36:31 03/05/13 I have a Z1 tuned ECU. Its it possible for one to lose its - z32z 20:50:10 03/05/13 No, not really possible. Moreso if you have the wrong tune - Summeronthechain (MN) 07:24:28 03/06/13 check your timing - Zvil (FL) 21:00:53 03/05/13 Timing is correct. I think I counted the teeth 30 times. I - z32z 21:19:50 03/05/13 tps? (n/m) - inf 22:37:25 03/05/13 Began to stumble after you swapped heads? (n/m) - Gordo 93TT Daytona 10:14:30 03/06/13 Yes. My timing belt jumped and bent a valve. I sent a extra - z32z 10:56:17 03/06/13 Sounds like a bad maf sensor (n/m) - ForceFedTT (SoCal) 03:34:37 03/10/13
Post a Followup	You cannot reply to this message because you are not logged in.