Subject	you need to make sure the connector for the wiring harness
Posted by	Zvil (FL) on February 26, 2013 at 9:09 AM
	This message has been viewed 148 times.
In Reply To	notice my computer when i move it car stalls why ? posted by BlackTwins on February 26, 2013 at 06:34 AM
Message	is fully seated to the ECU, try unscrewing the 10mm bolt in the center, remove the connector then re-connect it and screw the bolt all the way down and press on the ends to verify it is completely seated, if the problem still persists you can either troubleshoot which wires on the harness are disconnecting by wiggling each one while the ecu is detached from the chassis OR buy a new harness and have it installed professionally. *disclaimer*: all that I say may be true or I may be completely wrong and I accept that.... please, it is your duty as another person on the internet to in-politely tell me how wrong I am :) "The dreaded 2nd windshiled wiper swipe when you turn it off its almost like tis showing you that it's boss, and it doesn't have to stop when you tell it to :("-College Boy (discussion on ptu relocation) "No good reason to put it there anyway. -Bernie (NoVA) False -vorpalZ False. -Bernie (NoVA) You're correct, there are 3 good reasons -vorpalZ False. -Bernie (NoVA) Wow, right again, just remembered another, make that 4 -vorpalZ" XD
Follow Ups	notice my computer when i move it car stalls why ? - BlackTwins 06:34:13 02/26/13 So your post is very hard to understand. - Summeronthechain (MN) 08:55:14 02/26/13 you need to make sure the connector for the wiring harness - Zvil (FL) 09:09:13 02/26/13 troll - fuzzymonkey 11:45:40 02/26/13 VTD both posts, poor Z. (n/m) - Tanley 08:33:02 02/27/13
Post a Followup	You cannot reply to this message because you are not logged in.