Subject	4 basic problems...
Posted by	Zinprogress on February 20, 2013 at 8:56 AM
	This message has been viewed 208 times.
In Reply To	Really comes down to one of four basic issues... posted by jzack on February 18, 2013 at 05:53 PM
Message	Thermostat is new, water pump works good, went ahead and replaced cap with a locking one... Donesnt seem blocked... I blew a hose from clamping it too tight... What I'll do now is bleed/ burp the system and make sure there are no leaks for pressure... Is anyone aware of lines under the motor or plenum after water plenum delet?
Follow Ups	Heater/ heating problem - Zinprogress 21:21:19 02/16/13 Re: Heater/ heating problem - someotherguy 21:33:41 02/16/13 Re: Re: Heater/ heating problem - Zinprogress 21:38:38 02/16/13 Your post is very hard to follow. - Summeronthechain (MN) 22:22:26 02/16/13 Re: Your post is very hard to follow. - Zinprogress 23:59:20 02/16/13 Sounds to me like there's a clog somewhere? I would guess - jzack 09:05:36 02/17/13 I feel air flow - Zinprogress 11:42:26 02/17/13 Well then, perhaps a block on the engine side? - jzack 16:17:58 02/17/13 No block just no pressure - Zinprogress 16:32:04 02/17/13 Maybe bad water pump ? (n/m) - jlag 09:16:08 02/18/13 I don't think so... - Zinprogress 15:54:09 02/18/13 Really comes down to one of four basic issues... - jzack 17:53:25 02/18/13 4 basic problems... - Zinprogress 08:56:40 02/20/13 My no heat problem is the blend door - BigZness 11:51:57 02/20/13 Bleeding - Zinprogress 22:39:00 02/21/13 Problem solved! (info in box) - Zinprogress 16:59:26 02/25/13 You're welcome. - Woody75 (Denver) 15:05:06 02/26/13 I got rid of it... Only thing I didn't take out was thheater - Zinprogress 22:57:46 02/27/13
Post a Followup	You cannot reply to this message because you are not logged in.