Subject	Wiper blades...
Posted by	dzero196 on February 19, 2013 at 8:10 PM
	This message has been viewed 282 times.
Message	Alright so i finally got my project running right, and i realize my wipers are no longer working. Typical. Ok so i go through the system, first check the fuse, thats fine then wiggle the fuse with the wipers on... no go again. So then i start looking at wiring schematics, i run a 12 volt and ground to the motor and boom wipers are working, ok next step i leave the wipers up plug the motor back in and the wipers go down. Ok so its getting some sort of power, and everything else (part of that system) works rear wiper, spray nozzel front and rear. Anyone have any insight into this problem? I have come to the conclusion that its either the wiper amp or the time control unit in the pod.
Follow Ups	Wiper blades... - dzero196 20:10:16 02/19/13 can you get a spare pod to check... - Medallion Man 02:00:54 02/20/13 Re: can you get a spare pod to check... - dzero196 16:29:48 02/23/13
Post a Followup	You cannot reply to this message because you are not logged in.