Subject	i had trouble finding one on the back side of the motor...
Posted by	BOOZT_JUNKIE on February 05, 2013 at 4:17 PM
	This message has been viewed 166 times.
In Reply To	using boost leak tester...still can't find leak! posted by drew32 on February 02, 2013 at 04:43 PM
Message	turned out to be the exhaust valve cover seal (half-moon rubber gasket on the backside of the exhaust valve covers) you can test it there, its hard to see bubbles back there, but you can feel it with your hand. this was at least one of my many leaks.
Follow Ups	using boost leak tester...still can't find leak! - drew32 16:43:53 02/02/13 PCV on underside of plenum near balance tube flange - madscientist222 16:56:05 02/02/13 it is probably original with ˜80k on it - drew32 22:52:56 02/02/13 Sounds like the old rubber may be cracked/worn. - madscientist222 13:36:48 02/03/13 ok thanks all. I ordered new PCVs and hoses - drew32 14:57:52 02/03/13 ^^ 2nd - SammybTT(TN) 22:54:34 02/02/13 I don't think boost should pass through to the hose - njz 08:00:00 02/03/13 right now i have a compressor hooked up to the intake - drew32 10:17:37 02/03/13 I talking when boosting not 5 PSI air. (n/m) - njz 17:21:20 02/03/13 Yes, I believe there should be - Summeronthechain (MN) 11:19:18 02/03/13 Boost shouldnt, but a boost leak test will pressurize both - madscientist222 13:38:10 02/03/13 Idle valve? (n/m) - JonnyZ(SoCal) 23:01:03 02/03/13 if you can feel it, you can find it . If you have big hands - Xteam300TT (South Tx ) 23:23:07 02/03/13 i had trouble finding one on the back side of the motor... - BOOZT_JUNKIE 16:17:46 02/05/13
Post a Followup	You cannot reply to this message because you are not logged in.