Subject	Is it normal to have a lot of play in the center
Posted by	NextZ on February 04, 2013 at 9:28 AM
	This message has been viewed 153 times.
In Reply To	normal (n/m) posted by Drk93TT on February 03, 2013 at 07:47 PM
Message	of the driveshaft? I can move mine about an inch up and down. I get a bad vibration between 20 and 60mph. http://www.flickr.com/photos/90646678@N06/8231564752/
Follow Ups	In/ out Play in driveshaft at diff connection? - Jkova300z 18:49:59 02/03/13 normal (n/m) - Drk93TT 19:47:38 02/03/13 Is it normal to have a lot of play in the center - NextZ 09:28:53 02/04/13 If stock, no, should be no play at carrier bearing. (n/m) - Zinister1 10:19:50 02/04/13 Thanks! Now to order a new one piece ds (n/m) - NextZ 10:44:04 02/04/13 You may want to search and read first. If vibration - zellamay 11:29:35 02/04/13 Or you can replace the center bearing... (n/m) - Bernie (NoVA) 15:17:22 02/04/13 I wasn't sure if they were replaceable. - NextZ 16:48:00 02/04/13 I have a Z1 1piece DS, and I have vibrations - MrPulldown(Tahoe) 15:26:54 02/04/13 Go have it balanced, before you kill the trans seal (n/m) - njz 21:03:59 02/04/13 "bucking" as in..... - LJZTT 13:15:46 02/04/13 Yes that is what I was thinking. On/Off throttle jerkiness - Gordo 93TT Daytona 21:34:55 02/04/13 So to clarify, I was stating the bucking was from - Jkova300z 02:02:27 02/05/13 You are describing the symptoms. For more info - Gordo 93TT Daytona 09:35:41 02/05/13 I asked Greg D if he could make me another tune using - Evan_Wright (Ca) 18:25:20 02/05/13 I did not make any changes to timing in the zones that - Gordo 93TT Daytona 19:12:27 02/05/13 Also want to add that none of this would be necessary - Gordo 93TT Daytona 19:30:46 02/05/13 I have the same problems and like you I have spent many - Evan_Wright (Ca) 10:10:45 02/06/13 Yea, ^ that's exactly what I'm referring to. What is that? (n/m) - Jkova300z 02:03:54 02/05/13 Yea, ^ that's exactly what I'm referring to. What is that? (n/m) - Jkova300z 10:33:26 02/05/13
Post a Followup	You cannot reply to this message because you are not logged in.