Subject	You checked the PTU, did you check the PTU sub-harness?
Posted by	madscientist222 on February 02, 2013 at 4:51 PM
	This message has been viewed 213 times.
In Reply To	Tensioner Stud Broke posted by ZonaZ on January 31, 2013 at 07:50 PM
Message	Ive had my harness not be secure, and in contact with the power steering pulley causing a dead cylinder from the pulley wearing the wire coating away. The wires werent broken, so continuity was there, but when firing it would ground out to the pulley so no signal to fire the coil... I dont see how you would have good compression if the valve contacted the pistons.
Follow Ups	Tensioner Stud Broke - ZonaZ 19:50:45 01/31/13 Do you have access to a leakdown tester? (n/m) - ttsmokin 22:37:22 01/31/13 that is the next step, try to barrow one today. or buy (n/m) - ZonaZ 07:59:25 02/01/13 Hellofa dilemma. Sorry, got nothing. Best of luck! - OverZealous (CT) 18:12:20 02/01/13 bet a leak down finds the issue. (n/m) - Z32TT-R 13:14:52 02/02/13 You checked the PTU, did you check the PTU sub-harness? - madscientist222 16:51:20 02/02/13 yeah checked those, look ok (n/m) - ZonaZ 11:19:42 02/03/13 is the plug firing? - aliaZ 09:21:31 02/03/13 yes, plug is firing (n/m) - ZonaZ 11:17:22 02/03/13 you should do a leakdown test (n/m) - aliaZ 00:28:29 02/04/13
Post a Followup	You cannot reply to this message because you are not logged in.