Subject	Hellofa dilemma. Sorry, got nothing. Best of luck!
Posted by	OverZealous (CT) on February 01, 2013 at 6:12 PM
	This message has been viewed 218 times.
In Reply To	Tensioner Stud Broke posted by ZonaZ on January 31, 2013 at 07:50 PM
Message	I would expect if compression was good you'd be ok. Only an experienced machine shop guy might have this kind of insight. Try Kyle @ IPP? Please follow up this post whenever you figure it out. OverZealous (CT) My General posts (click) My Technical posts (click)
Follow Ups	Tensioner Stud Broke - ZonaZ 19:50:45 01/31/13 Do you have access to a leakdown tester? (n/m) - ttsmokin 22:37:22 01/31/13 that is the next step, try to barrow one today. or buy (n/m) - ZonaZ 07:59:25 02/01/13 Hellofa dilemma. Sorry, got nothing. Best of luck! - OverZealous (CT) 18:12:20 02/01/13 bet a leak down finds the issue. (n/m) - Z32TT-R 13:14:52 02/02/13 You checked the PTU, did you check the PTU sub-harness? - madscientist222 16:51:20 02/02/13 yeah checked those, look ok (n/m) - ZonaZ 11:19:42 02/03/13 is the plug firing? - aliaZ 09:21:31 02/03/13 yes, plug is firing (n/m) - ZonaZ 11:17:22 02/03/13 you should do a leakdown test (n/m) - aliaZ 00:28:29 02/04/13
Post a Followup	You cannot reply to this message because you are not logged in.