Subject	No codes...
Posted by	platinumist on January 30, 2013 at 9:50 PM
	This message has been viewed 105 times.
In Reply To	Safety boost after plenum pull... posted by platinumist on January 28, 2013 at 05:03 PM
Message	Only code 55. If my stock boost gauge is dead, I thought it could be my boost pressure sensor (to my understanding this would throw a CEL anyways: [ http://www.ttzd.com/tech/diagnostictech.html ]), but no. I also tried disabling the boost cut solenoid circuit with the JWT method but STILL safety boost... Is there anything that I could have hooked up wrong that would cause this? Should I just take them out since I plan to anyway?
Follow Ups	Safety boost after plenum pull... - platinumist 17:03:21 01/28/13 Get the ECU codes anyway. - Stokens (StoMoZTT) 17:20:56 01/28/13 When you install your EBC, do power the valve with - JMartz 20:18:51 01/28/13 No codes... - platinumist 21:50:41 01/30/13 Re: Safety boost after plenum pull... - ThisIsSparTTa 12:14:22 01/31/13 Re: Re: Safety boost after plenum pull... - platinumist 00:30:40 02/01/13
Post a Followup	You cannot reply to this message because you are not logged in.