Subject	Will the engine turn over using the crank pulley nut?
Posted by	Gordo 93TT Daytona on January 23, 2013 at 6:01 PM
	This message has been viewed 243 times.
In Reply To	Possible engine failure....any thoughts...? posted by jmt-z on January 22, 2013 at 11:41 AM
Message	If it moves back and forth, but doesn't rotate very far; then it is not seized, but you probably have an obstruction, like a valve into a piston. _________________________________________________
Follow Ups	Possible engine failure....any thoughts...? - jmt-z 11:41:53 01/22/13 check ecu for codes. might be a loose connection. look for - Krazyd27(Houston) 12:31:33 01/22/13 Re: Possible engine failure....any thoughts...? - craigz96tt (SC) 14:11:03 01/22/13 2nd, that sounds precisely like a timing belt issue. (n/m) - TriniTT 15:38:29 01/22/13 and we have a winner..... I was seriously leaning towards - jmt-z 16:07:11 01/22/13 I'd say your motor is probably toast based on your reaction - TriniTT 16:16:06 01/22/13 Are you running without T-belt covers? - Zvil (FL) 17:38:45 01/22/13 Left the timing belt covers off from the last time i was - jmt-z 18:07:28 01/22/13 Sorry to hear - SeanK (StL) 11:51:21 01/23/13 Yeah man I would have taken you up with it but i already - jmt-z 17:28:59 01/23/13 2 thoughts.... - Zvil (FL) 17:32:55 01/22/13 Just my 2 cents - boostlv 12:04:04 01/23/13 check your starter - boostlv 12:08:14 01/23/13 Will the engine turn over using the crank pulley nut? - Gordo 93TT Daytona 18:01:05 01/23/13
Post a Followup	You cannot reply to this message because you are not logged in.