Subject	Re: Re: Re: Bore clearance question?
Posted by	Tech@EPR on January 16, 2013 at 5:48 AM
	This message has been viewed 150 times.
In Reply To	Re: Re: Bore clearance question? posted by wickdGSXR on January 15, 2013 at 12:30 AM
Message	3.2L with just piston displacement and no stroke? The stock block doesn't have enough material in the bores to adopt a piston much bigger than 89mm. Some are lucky to get away with 90mm but you are getting REALLY risky in doing so. If you wanted to run that much bore I'd of suggested to go with a hardened sleeve and then bore out to desired diameter. Ep Racing | Create Your Badge
Follow Ups	Bore clearance question? - tt_703 12:13:50 01/11/13 Re: Bore clearance question? - Tech@EPR 18:08:43 01/11/13 Re: Re: Bore clearance question? - wickdGSXR 00:30:13 01/15/13 Re: Re: Re: Bore clearance question? - Tech@EPR 05:48:52 01/16/13
Post a Followup	You cannot reply to this message because you are not logged in.