Subject	Advice Needed
Posted by	Beachy on January 13, 2013 at 6:05 PM
	This message has been viewed 242 times.
Message	I'm preparing to repaint my engine bay a new color (darker shade of gray). As some of you may recall, I had a fire in the engine bay about a year ago, so some of my wiring has been destroyed. My main engine room wiring harness is mostly intact, except for a few areas- near the master cylinders, leading to the wiper motor, and leading to the power steering pressure sensor and variable assist valve. In light of the not inconsiderable amount of work involved, and potential pitfalls, I am considering repairing the existing harness in place, utilizing the one I purchased used for parts. Alternatively, I could replace the entire harness with the used one. This option looks like an enormous PITA, and may not yield better results. Any ideas? I believe I could paint around said harness, without overspray, and could perform quality repairs to it, without entirely replacing it. Below are some pics of my Z, as it sits today:
Follow Ups	Advice Needed - Beachy 18:05:27 01/13/13 I have experience swapping out every harness on the entire - Zvil (FL) 20:02:24 01/13/13 Re: I have experience swapping out every harness on the entire - Beachy 20:17:55 01/13/13 I believe you can remove the front harness without taking - Zvil (FL) 21:18:13 01/13/13 ^^ this is correct^^ - white22sky 08:26:05 01/14/13 Gotta agree w/ Zvil. Electrical problems are hard enought - Gordo 93TT Daytona 20:25:51 01/13/13
Post a Followup	You cannot reply to this message because you are not logged in.