Subject	Re: Chirping Sound
Posted by	ZxMoslowxZ on December 30, 2012 at 11:08 AM
	This message has been viewed 154 times.
In Reply To	Chirping Sound posted by 311zx on December 29, 2012 at 04:36 PM
Message	Yes it could. Do you have an aftermarket underdrive pulley? if so sometimes under a good electrical load the belt will slip. Im thinking maybe becuase its smaller & polished or your could be bent a little but my friends Z does the same thing and we cant figure it out either
Follow Ups	Chirping Sound - 311zx 16:36:08 12/29/12 Yes, belts need to be tightened to spec. (n/m) - Summeronthechain (MN) 17:26:45 12/29/12 Re: Chirping Sound - ZxMoslowxZ 11:08:27 12/30/12 No, there is no such thing as a belt being too tight. - zellamay 11:33:38 12/30/12 don't go too tight or your water pump bearing will fail - Zvil (FL) 11:40:51 12/31/12
Post a Followup	You cannot reply to this message because you are not logged in.