Subject	Seems that I found what replicates the problem....
Posted by	jmt-z on December 23, 2012 at 1:51 PM
	This message has been viewed 167 times.
In Reply To	Figured I would throw this out there while i am working on posted by jmt-z on December 22, 2012 at 11:53 AM
Message	Whenever I rev the engine up over 6-6500 under load and the go directly onto the clutch the revs fall and stumble a bit and then dies. Fires right back up whoever I pop the clutch but it just doesn't want to keep stable. Any less revs than that and it seems to level out just fine though. "If everything seems under control, you're just not going fast enough." - Mario Andretti
Follow Ups	Figured I would throw this out there while i am working on - jmt-z 11:53:41 12/22/12 Try this: - TriniTT 17:46:35 12/22/12 Thanks, but the symptoms don't seem to match. My hesitation - jmt-z 11:12:28 12/23/12 Think about the theory of operation. - TriniTT 12:03:02 12/23/12 Re: Figured I would throw this out there while i am working on - Project_Broke 19:34:06 12/22/12 Seems that I found what replicates the problem.... - jmt-z 13:51:12 12/23/12 Dashpot Function - Cjw3 17:15:12 12/23/12 Sounds like you iaa/tps isn't set right. - TriniTT 17:20:47 12/23/12 They were, but I will double check them again (n/m) - jmt-z 11:17:19 12/24/12
Post a Followup	You cannot reply to this message because you are not logged in.