Subject	Rethink..
Posted by	Cjw3 on December 21, 2012 at 6:52 AM
	This message has been viewed 198 times.
In Reply To	Good Call...Should get a back up just in case posted by LoqueZ32(SoCal) on December 20, 2012 at 10:55 PM
Message	You will need a Bit of Solderwick, and some flux, new solder, and Little Prybars.. For as long of a chip as this, it's a Slow Wiggle to figure out what leg is Hung up ( This Time ).. and you will heat and suck or apply solder to get the Chip to move. I have found that Applying new solder to a difficult leg, then sucking it back off will help in heat transfer.. Good Luck.. and my the Patience of Jobe be with you.. Cj
Follow Ups	EPROM Socket Recommendations - LoqueZ32(SoCal) 15:07:26 12/20/12 I found generally this type of socket to be pretty - jzack 16:26:39 12/20/12 Questions.. - Cjw3 21:24:57 12/20/12 Good Call...Should get a back up just in case - LoqueZ32(SoCal) 22:55:45 12/20/12 Rethink.. - Cjw3 06:52:24 12/21/12 nice (n/m) - aliaZ 07:12:28 12/21/12
Post a Followup	You cannot reply to this message because you are not logged in.