Subject	There's a chart in FSM w/ standard bolt sizes/torque setting
Posted by	EUGENE on December 20, 2012 at 4:58 AM
	This message has been viewed 201 times.
In Reply To	well, after some research I found some guy on here saying posted by inf on December 17, 2012 at 09:04 PM
Message	There are a few errors in regards to torque settings in the FSM. When I'm working on something new, I will pay attention to the torque numbers in the diagrams. But if the numbers are way off from that standard chart, I may choose to ignore them.
Follow Ups	Anyone else had problems torquing the VTC bolts down? - inf 17:53:59 12/17/12 Umm, are the threads stripped? (n/m) - Summeronthechain (MN) 19:17:15 12/17/12 I was thinking they might be, but I did another Z's the - inf 20:50:02 12/17/12 well, after some research I found some guy on here saying - inf 21:04:29 12/17/12 There's a chart in FSM w/ standard bolt sizes/torque setting - EUGENE 04:58:56 12/20/12 Weird...I just took one of the bolts out and it looks - inf 00:42:43 12/18/12
Post a Followup	You cannot reply to this message because you are not logged in.