Subject	well, after some research I found some guy on here saying
Posted by	inf on December 17, 2012 at 9:04 PM
	This message has been viewed 171 times.
In Reply To	Umm, are the threads stripped? (n/m) posted by Summeronthechain (MN) on December 17, 2012 at 07:17 PM
Message	the diagram in the FSM states the wrong amount of torque and almost stripped his, lol...great...I assume it's 9ft lb's not 12-18 ft lbs. Well, at least both of these are still holding at 13 ft lbs.
Follow Ups	Anyone else had problems torquing the VTC bolts down? - inf 17:53:59 12/17/12 Umm, are the threads stripped? (n/m) - Summeronthechain (MN) 19:17:15 12/17/12 I was thinking they might be, but I did another Z's the - inf 20:50:02 12/17/12 well, after some research I found some guy on here saying - inf 21:04:29 12/17/12 There's a chart in FSM w/ standard bolt sizes/torque setting - EUGENE 04:58:56 12/20/12 Weird...I just took one of the bolts out and it looks - inf 00:42:43 12/18/12
Post a Followup	You cannot reply to this message because you are not logged in.