Subject	Installing the Innovate LC-1...
Posted by	Z ONLY1 on November 27, 2012 at 7:21 AM
	This message has been viewed 302 times.
Message	I'm getting ready to bring Z in for winter. While it's on stands.... thought I'd run the LC-1 into the car (A/F gauge), then do all electrical while it's in a heated garage. I know it gets calibrated open air and then has capabilities/maintenance of re-calibrating over time. Question, if I install the sensor and drive a little before I finish the entiring wiring, will the initial calibration be ok after driving? Since it should be re-calibrated periodically, seems this would be ok to do....anybody have thoughts on this. Thanks
Follow Ups	Installing the Innovate LC-1... - Z ONLY1 07:21:35 11/27/12 How do you mean 'finish the wiring'? - Broke_as_**** 07:46:43 11/27/12 I would say no.. - Drk93TT 07:48:36 11/27/12 Since im lazy and dont feel like searching.. - Drk93TT 07:50:18 11/27/12 Got it.... - Z ONLY1 09:16:00 11/27/12 Oh, sorry moderators, thought I posted in tech,my mistake. - Z ONLY1 09:19:43 11/27/12 It's all in the manual you know - Broke_as_**** 09:19:57 11/27/12 yup, I know....just didn't know if not completely connected. - Z ONLY1 09:52:07 11/27/12 I have the LM1 in my car and after a year I've never had to - craigz96tt 08:49:13 11/29/12
Post a Followup	You cannot reply to this message because you are not logged in.