Subject	Fitting won't work
Posted by	NextZ on November 26, 2012 at 1:10 PM
	This message has been viewed 158 times.
Message	I bought the 90 degree fitting that relocates the oil pressure sensor. The fitting is used to prevent the oil pressure sensor from hitting the turbo. The problem is when I tighten the fitting down it stops right where the oil filter goes. I thought about grinding down the threads so the fitting would bottom out without interfering with the oil filter. Any other suggestions?
Follow Ups	Fitting won't work - NextZ 13:10:40 11/26/12 Teflon tape. (n/m) - my91z 20:14:49 11/26/12
Post a Followup	You cannot reply to this message because you are not logged in.