Subject	get a dremal tool , knotch each side and use a large
Posted by	Xteam300TT (South Tx ) on November 23, 2012 at 9:29 PM
	This message has been viewed 175 times.
In Reply To	Timing Belt cover bolt help posted by JUNz (?00)rwhp on November 23, 2012 at 05:53 PM
Message	flat head screw driver or flat punch/chisle with vise grips . good luck
Follow Ups	Timing Belt cover bolt help - JUNz (?00)rwhp 17:53:55 11/23/12 Wow, how the hell did that happen?? Well youve exhausted - jmt-z 18:58:46 11/23/12 Apply some heat to the back side of the rear plates - Broke_as_**** 19:24:19 11/23/12 Re: Timing Belt cover bolt help - thomasfortney 20:13:35 11/23/12 Re: Timing Belt cover bolt help - Tech@EPR 20:47:36 11/23/12 Do this, you'll have them all out in minutes. (n/m) - TriniTT 07:38:52 11/26/12 get a dremal tool , knotch each side and use a large - Xteam300TT (South Tx ) 21:29:16 11/23/12 ^+1 (n/m) - Zvil (FL) 17:18:39 11/24/12 1/4" drive impact driver goes a long way on these cars (n/m) - craigz96tt 07:30:41 11/24/12 Re: 1/4" drive impact driver goes a long way on these cars - dragonback 09:38:53 11/24/12 ^If the dremel method doesn't work try this (n/m) - Zvil (FL) 17:22:45 11/24/12 Hack the cover and get a transparent one. (n/m) - JMartz 11:58:50 11/25/12 drill the heads off (n/m) - aliaZ 17:17:00 11/25/12 Re: Timing Belt cover bolt help - supergoji 00:19:44 12/03/12
Post a Followup	You cannot reply to this message because you are not logged in.