Subject	Re: Timing Belt cover bolt help
Posted by	Tech@EPR on November 23, 2012 at 8:47 PM
	This message has been viewed 184 times.
In Reply To	Timing Belt cover bolt help posted by JUNz (?00)rwhp on November 23, 2012 at 05:53 PM
Message	drill a hole down the middle and get yourself a set of SNAPON extractors...they are VERY hard and take out just about anything. The bits have the size drill bit needed to drill the hole so the extractor can fit in there and bite into the material. Good luck Ep Racing | Create Your Badge
Follow Ups	Timing Belt cover bolt help - JUNz (?00)rwhp 17:53:55 11/23/12 Wow, how the hell did that happen?? Well youve exhausted - jmt-z 18:58:46 11/23/12 Apply some heat to the back side of the rear plates - Broke_as_**** 19:24:19 11/23/12 Re: Timing Belt cover bolt help - thomasfortney 20:13:35 11/23/12 Re: Timing Belt cover bolt help - Tech@EPR 20:47:36 11/23/12 Do this, you'll have them all out in minutes. (n/m) - TriniTT 07:38:52 11/26/12 get a dremal tool , knotch each side and use a large - Xteam300TT (South Tx ) 21:29:16 11/23/12 ^+1 (n/m) - Zvil (FL) 17:18:39 11/24/12 1/4" drive impact driver goes a long way on these cars (n/m) - craigz96tt 07:30:41 11/24/12 Re: 1/4" drive impact driver goes a long way on these cars - dragonback 09:38:53 11/24/12 ^If the dremel method doesn't work try this (n/m) - Zvil (FL) 17:22:45 11/24/12 Hack the cover and get a transparent one. (n/m) - JMartz 11:58:50 11/25/12 drill the heads off (n/m) - aliaZ 17:17:00 11/25/12 Re: Timing Belt cover bolt help - supergoji 00:19:44 12/03/12
Post a Followup	You cannot reply to this message because you are not logged in.