Subject	Clutch suddenly slipping badly. How to troubleshoot?
Posted by	yobobrox on November 22, 2012 at 1:35 PM
	This message has been viewed 229 times.
Message	Hey guys, I have a low mileage, ~5k miles,clutch that I adjusted per specialty z instructions and bled. The engagement point has always been just about a half inch from fully released pedal. Now it is suddenly slipping under any load more than idle. I think it must have been slipping under heavy load before and I just didn't know it. I have now adjusted the pedal rod inward so that the pedal doesn't come up as far, and I had to rebleed the clutch to get any engagement, but nothing seems to have changed after bleeding - it now slips and engages just like it did before I touched anything. I have only been bleeding under the hood and I'll put the car up and bleed at slave cylinder in a little bit. Clutch is a Dxd Southbend Kevlar blend with the HD clutch fork.
Follow Ups	Clutch suddenly slipping badly. How to troubleshoot? - yobobrox 13:35:03 11/22/12 The clutch requires bleeding at both top and bottom. - Gordo 93TT Daytona 19:44:27 11/22/12 May be too late but as Gordo said you must bleed both upper - craigz96tt 08:04:13 11/23/12 Clutch confirmed to be toast. Thnx tho (n/m) - yobobrox 11:13:55 11/23/12 Set the engagement point of the new clutch lower to the - Gordo 93TT Daytona 16:02:22 11/23/12
Post a Followup	You cannot reply to this message because you are not logged in.