Subject	Re: Contact the memer Lumpdonut on this forum
Posted by	MJzTTZ on November 16, 2012 at 8:38 PM
	This message has been viewed 230 times.
In Reply To	Contact the memer Lumpdonut on this forum posted by Hydrus on November 16, 2012 at 04:33 PM
Message	will do... thanks for the help offer. I tried to ohm test the injectors... set the multimeter to 200. When i tested the culprit injectors... the ohm meter didnt register anything. When i tested a cylinder that is suppose to be fine, it showed about 12.46 on the meter. So i am guessing the 3 driver side injectors have gone bad.
Follow Ups	Any Z expert in tulsa, ok - MJzTTZ 21:56:30 11/15/12 Couple thoughts... - Stokens (StoMoZTT) 13:06:32 11/16/12 Link: - Stokens (StoMoZTT) 13:14:28 11/16/12 Contact the memer Lumpdonut on this forum - Hydrus 16:33:46 11/16/12 Re: Contact the memer Lumpdonut on this forum - MJzTTZ 20:38:04 11/16/12 Re: Link: - MJzTTZ 20:35:04 11/16/12 Bummer! Was hoping for an easy fix. Good luck :-/ (n/m) - Stokens (StoMoZTT) 08:08:56 11/17/12
Post a Followup	You cannot reply to this message because you are not logged in.