Subject	Re: Compression Check
Posted by	Medallion Man on November 11, 2012 at 2:12 AM
	This message has been viewed 131 times.
In Reply To	Compression Check posted by Cjw3 on November 10, 2012 at 10:33 PM
Message	agree with comments above... how did you do the belt? did you follow the guide in the SM? (it shows you how many teeth to count). lining up the marks wont do the job right (unless you're lucky). you need to check it again.. page EM16 has a diagram with cog count. [ http://stadzport.com/FSM/EM_Engine_Mechanical.pdf ]
Follow Ups	Timing Help requested - tangeray 19:03:19 11/10/12 I think there's 4 things that might be throwing timing off - Zvil (FL) 19:42:02 11/10/12 Re: I think there's 4 things that might be throwing timing off - tangeray 20:34:11 11/10/12 Compression Check - Cjw3 22:33:44 11/10/12 Re: Compression Check - Medallion Man 02:12:03 11/11/12 How are you checking the timing? (n/m) - craigz96tt 07:21:13 11/11/12 ^^^This^^^^ - Zinister1 10:12:54 11/11/12 Re: ^^^This^^^^ - tangeray 10:36:41 11/11/12 Re: Re: ^^^This^^^^ - tangeray 10:37:48 11/11/12 Re: Re: ^^^This^^^^ - Cjw3 11:32:48 11/11/12 Should run good at 17. + or - 2 from 15. (n/m) - brian913 15:48:30 11/11/12 Re: Timing Help requested - craigz96tt 07:56:53 11/12/12
Post a Followup	You cannot reply to this message because you are not logged in.