Subject	Simple explanation inside.
Posted by	Summeronthechain (MN) on November 08, 2012 at 9:28 AM
	This message has been viewed 147 times.
In Reply To	parking break not engaging posted by jonting421 on November 08, 2012 at 08:45 AM
Message	When you pull up on the lever, it pulls a cable that runs from the lever to the rear of the car which then Ys and goes to each rear hub. When the cables are pulled tight it pulls pads on each hub tight up against the hub of the inside of the brake rotor, similar to a drum brake. Now to do a wheel bearing, they have to work near the ebrake assembly and most likely disassembled it and failed to reassembly it properly. Take it back and make them fix it. Also, have them adjust the cable tension to the proper amount.
Follow Ups	parking break not engaging - jonting421 08:45:04 11/08/12 For starters, make sure the lines are connected... - johnnysombrero 09:25:23 11/08/12 Simple explanation inside. - Summeronthechain (MN) 09:28:33 11/08/12 May just not be adjusted properly - Jayru 11:38:24 11/08/12 Is that documented anywhere? FSM? (n/m) - Woody75 (Denver) 13:02:37 11/08/12 This was tought to me by my dad years ago - Jayru 13:20:14 11/08/12 Guess not, my bad... - Jayru 13:23:02 11/08/12 Was gonna say I didnt think they did, hence why I asked. - Woody75 (Denver) 14:07:51 11/08/12 Re: May just not be adjusted properly - craigz96tt 08:15:36 11/10/12 There is an adjustment at the handle. But this is the final - Gordo 93TT Daytona 11:36:16 11/10/12
Post a Followup	You cannot reply to this message because you are not logged in.