Subject	one thing I learned recently
Posted by	aliaZ on November 04, 2012 at 7:27 AM
	This message has been viewed 175 times.
In Reply To	Trying to be ready for SZ tuning, next week.... posted by Z ONLY1 on November 03, 2012 at 06:51 PM
Message	is that when specialty Z adjusts the TPS, they adjusted it until the idle switch was on (as shown in conzult software). This was usually below the .4 to .5 volt spec... This isn't mentioned anywhere in the FSM...
Follow Ups	Trying to be ready for SZ tuning, next week.... - Z ONLY1 18:51:19 11/03/12 Are you aware that you must disconnet the tps completely - Zvil (FL) 21:45:27 11/03/12 +1. Unplug gray oval connector for 10 seconds w/key on. (n/m) - Stadsport (Nick@CZP) 00:13:52 11/04/12 That's hard idle switch but he's having other issue (n/m) - craigz96tt 10:38:48 11/05/12 one thing I learned recently - aliaZ 07:27:05 11/04/12 I just learned something too. Thanks. (n/m) - ThunderZ 19:50:34 11/04/12 Not in my experience. - Bernie (NoVA) 23:41:59 11/04/12 I suppose it depends on the condition of the TPS (n/m) - aliaZ 17:34:09 11/05/12 yeah I have a couple "messed up" ones that will - Zvil (FL) 17:43:28 11/05/12 Reduce tps to .38 without any adverse effects and will lower - craigz96tt 07:46:46 11/04/12 thanks, going back to it today...... - Z ONLY1 08:04:40 11/04/12
Post a Followup	You cannot reply to this message because you are not logged in.