Subject	Re: Concern on recent 120k job done. Checking my timing
Posted by	elcid on October 17, 2012 at 6:14 PM
	This message has been viewed 127 times.
In Reply To	Concern on recent 120k job done. Checking my timing posted by elcid on October 17, 2012 at 05:54 PM
Message	yup, I made sure she was fully warmed up. :( I can understand the timing being out but jumping around on me is a different pill i cant swallow.
Follow Ups	Concern on recent 120k job done. Checking my timing - elcid 17:54:38 10/17/12 Was the engine warm when you checked the timing. (n/m) - michaell32 (FL) 17:59:25 10/17/12 Re: Concern on recent 120k job done. Checking my timing - elcid 18:14:31 10/17/12 Might be a bad CAS or something else feeding into the timing - ZXoltan 18:16:09 10/17/12 Re: Might be a bad CAS or something else feeding into the timing - elcid 18:35:53 10/17/12 what kind of crank pulley are you using? (n/m) - fuzzymonkey 18:17:16 10/17/12 Re: what kind of crank pulley are you using? - elcid 18:36:42 10/17/12 I had the exact same problem you had with my UR pulley - fuzzymonkey 11:57:45 10/18/12 Did you dis-connect the tps or AAC? (n/m) - MeatMan - 604Z.ca - 18:38:37 10/17/12 Re: Did you dis-connect the tps or AAC? - elcid 18:44:31 10/17/12 Re: Concern on recent 120k job done. Checking my timing - brian913 07:08:58 10/18/12 Re: Re: Concern on recent 120k job done. Checking my timing - elcid 07:18:56 10/18/12 Re: Re: Concern on recent 120k job done. Checking my timing - elcid 08:46:17 10/18/12
Post a Followup	You cannot reply to this message because you are not logged in.