Subject	Concern on recent 120k job done. Checking my timing
Posted by	elcid on October 17, 2012 at 5:54 PM
	This message has been viewed 234 times.
Message	Hey guys. So as you may be aware, I did my first evern 120k job on my beaterZ ( NA ) and today, I finally went out and purchased a timing gun just to check out the Z and make sure she is good to go. Well, after arming myself with TT timing gun knowledege, I proceeded to use the round loop found in the PTU. Checked the timing... 25 degrees!. It kinda looked like it was jumping between 20-25. From previous research, I read that if you got some weird readings , to try and use the #1 wire, which I did with similar results. I adjusted the CAS to 15 and again , it looked like it was jumping between 10-17 degrees. Next, I proceeded to fire up my trusy laptop and hooked ConZult and the timing it reported was also jumping quickly between 12-15 degrees. I dont think its normal. When I did my belt and counted the cogs, etc...she fires up fine and appears to me that runs fine!. What do you think I should do next? thanks everyone!
Follow Ups	Concern on recent 120k job done. Checking my timing - elcid 17:54:38 10/17/12 Was the engine warm when you checked the timing. (n/m) - michaell32 (FL) 17:59:25 10/17/12 Re: Concern on recent 120k job done. Checking my timing - elcid 18:14:31 10/17/12 Might be a bad CAS or something else feeding into the timing - ZXoltan 18:16:09 10/17/12 Re: Might be a bad CAS or something else feeding into the timing - elcid 18:35:53 10/17/12 what kind of crank pulley are you using? (n/m) - fuzzymonkey 18:17:16 10/17/12 Re: what kind of crank pulley are you using? - elcid 18:36:42 10/17/12 I had the exact same problem you had with my UR pulley - fuzzymonkey 11:57:45 10/18/12 Did you dis-connect the tps or AAC? (n/m) - MeatMan - 604Z.ca - 18:38:37 10/17/12 Re: Did you dis-connect the tps or AAC? - elcid 18:44:31 10/17/12 Re: Concern on recent 120k job done. Checking my timing - brian913 07:08:58 10/18/12 Re: Re: Concern on recent 120k job done. Checking my timing - elcid 07:18:56 10/18/12 Re: Re: Concern on recent 120k job done. Checking my timing - elcid 08:46:17 10/18/12
Post a Followup	You cannot reply to this message because you are not logged in.