Subject	I like cjw3's answer. Remove the CaS turn the key on and
Posted by	Supermario680 (WI) on October 16, 2012 at 5:14 AM
	This message has been viewed 177 times.
In Reply To	Re: Engine won't start. Backfires. posted by Cjw3 on October 15, 2012 at 09:07 PM
Message	Turn the shaft on the CAS. This will trigger fuel and spark. Then lay out all the coils and ground the plugs on the plenum (away from fuel lines..) and visually check for spark in order. Front left front right middle left middle right, back left back right etc... Some with the injectors, just listen for thvclicks though. It could also be a poor spark causing excess fuel to build up and sporadically burn off when the spark is lit. Remove the CaS, turn the key On
Follow Ups	Engine won't start. Backfires. - 300ZXpert (someday) 20:23:02 10/15/12 Re: Engine won't start. Backfires. - njz 20:43:23 10/15/12 Re: Engine won't start. Backfires. - Cjw3 21:07:53 10/15/12 I like cjw3's answer. Remove the CaS turn the key on and - Supermario680 (WI) 05:14:54 10/16/12 You checked timing, but how?! - Drunkpunk082 13:59:47 10/16/12 It sounds like you've answered your own question. ;) (n/m) - 300ZXpert (someday) 19:49:10 10/16/12 Just wanted to make sure it was done right! (n/m) - Drunkpunk082 11:03:03 10/17/12
Post a Followup	You cannot reply to this message because you are not logged in.