Subject	Re: How long does your Z Hold pressure for during a boost leak?
Posted by	Stadsport (Nick@CZP) on October 14, 2012 at 7:33 AM
	This message has been viewed 301 times.
In Reply To	How long does your Z Hold pressure for during a boost leak? posted by Supermario680 (WI) on October 14, 2012 at 06:25 AM
Message	Before I did my engine pull (I haven't tested it on the new setup) I couldn't build pressure at all. The car ran fine, and I could never locate the leak, so take that as you will. We tested another member's around the same time (Piranha) and after fixing a few minor boost leaks, it didn't leak at ALL. You could literally take the compressor off and go have lunch and it wouldn't budge. I was mad jelly.
Follow Ups	How long does your Z Hold pressure for during a boost leak? - Supermario680 (WI) 06:25:46 10/14/12 Re: How long does your Z Hold pressure for during a boost leak? - Stadsport (Nick@CZP) 07:33:39 10/14/12 That's hard to believe. Usually you will get leaks past - Evan_Wright (Ca) 09:53:18 10/14/12 Mine will hold pressure longer than 5 seconds. - Summeronthechain (MN) 10:09:24 10/14/12 How much pressure,,?? - Drk93TT 12:52:31 10/14/12 5 psi to Zero (n/m) - Supermario680 (WI) 20:25:54 10/14/12 yep. 5 to 0 in like 20 secondsish (n/m) - Drk93TT 20:44:04 10/14/12 5 to 0 psi in about 25 seconds (n/m) - Gordo 93TT Daytona 05:10:27 10/17/12 Wow. I am amazed at the variation. Some people say theirs - Supermario680 (WI) 05:18:26 10/16/12
Post a Followup	You cannot reply to this message because you are not logged in.