Subject	Found this post while searching..will try it today..
Posted by	dvice on October 01, 2012 at 8:55 AM
	This message has been viewed 156 times.
In Reply To	How to test consult connector? posted by dvice on October 01, 2012 at 08:24 AM
Message	As it says in the following post, I have a '92 body with '95 engine and harness. Might be the solution. "have you had your efi harness replaced recently? - spyhunterTT(nj) 04/13/09 17:39:45 There is a secondary connector near the ecu that serves as the interface to a few items, specifically, the fuel pump and controller and the consult port. There are two pairs of wires that are identical colors...orange and yellow/red if I recall correctly. I ran into this issue with a customers car before. I swapped the wires and it started working again. Alex"
Follow Ups	How to test consult connector? - dvice 08:24:35 10/01/12 Found this post while searching..will try it today.. - dvice 08:55:52 10/01/12 nope..not that. (n/m) - dvice 13:11:23 10/01/12 Is the cable not working or is it the program?? - JoshE300zxTT 15:38:41 10/01/12 Cable is from ConceptZPerformance, tried 4 programs - dvice 13:39:24 10/04/12 ConZult is not reliable software - OverZealous (CT) 21:21:48 10/01/12 Is it the one found on Ebay packaged with free Conzult?? - mpmarino 12:31:45 10/04/12 No, cable is from ConceptZPerformance (n/m) - dvice 13:39:42 10/04/12 Re: No, cable is from ConceptZPerformance - mpmarino 17:38:53 10/04/12
Post a Followup	You cannot reply to this message because you are not logged in.