Subject	Re: Car will turn over & ECU flashes Code:34
Posted by	craigz96tt on September 30, 2012 at 9:32 AM
	This message has been viewed 170 times.
In Reply To	Car will turn over & ECU flashes Code:34 posted by MikeBaitZ on September 28, 2012 at 04:11 PM
Message	The wires on the connector get very brittle from the heat. Mine had a broken wire going into the harness so I replaced the male side and code went away. Good luck
Follow Ups	Car will turn over & ECU flashes Code:34 - MikeBaitZ 16:11:59 09/28/12 34 will put your car in safety boost, so you will only be - JonnyZ(SoCal) 16:42:02 09/28/12 Check your connectors, they may have swapped the O2 and your - Drunkpunk082 21:42:21 09/28/12 Re: Check your connectors, they may have swapped the O2 and your - MikeBaitZ 12:47:21 09/29/12 Yeah same thing. Connector is at the rear of the engine.. - Drunkpunk082 19:05:52 09/29/12 You mean det sensor and vtc. O2 is a 3 wire connector (n/m) - ztunerz 22:28:01 09/29/12 Re: Car will turn over & ECU flashes Code:34 - craigz96tt 09:32:31 09/30/12
Post a Followup	You cannot reply to this message because you are not logged in.