Subject	You would unhook one end of the link, adjust, then
Posted by	zellamay on September 29, 2012 at 8:34 PM
	This message has been viewed 167 times.
In Reply To	Re: That center piece is so short that it would be hard to posted by MaxxAction on September 29, 2012 at 06:22 PM
Message	put it back on. And I would take care to have both rod ends equally inside the adjuster nut. ..... What I meant was that if you have LH on one end, and RH on the other, there has to be some space in the middle with neither. You could make that space smaller, but it gets expensive. It's cheap and easy to have one thread through.
Follow Ups	Adjustable sway bar links not adjustable.. - MaxxAction 09:18:35 09/29/12 Re: Adjustable sway bar links not adjustable.. - MaxxAction 09:20:03 09/29/12 That center piece is so short that it would be hard to - zellamay 16:11:13 09/29/12 Re: That center piece is so short that it would be hard to - MaxxAction 18:22:02 09/29/12 You would unhook one end of the link, adjust, then - zellamay 20:34:18 09/29/12 Re: You would unhook one end of the link, adjust, then - MaxxAction 03:57:17 09/30/12 It's not tough to get the two sides equal. I install them - zQuikonE 16:48:21 09/30/12
Post a Followup	You cannot reply to this message because you are not logged in.