Subject	Car will turn over & ECU flashes Code:34
Posted by	MikeBaitZ on September 28, 2012 at 4:11 PM
	This message has been viewed 207 times.
Message	Recently had an aftermarket exhaust put on the car. I went to pick it up from the shop that performed the work, car will not start. Starter engages, smell a lot fuel, but the engine will not turn over. I pulled the ECU wood panel and checked the ECU and it was flashing 34, which is the Detonation Sensor Circuit code. Need some help, the mechanics are not very knowledgeable of this vehicle. Just wanna know potential issues. Thanks Mike Bates
Follow Ups	Car will turn over & ECU flashes Code:34 - MikeBaitZ 16:11:59 09/28/12 34 will put your car in safety boost, so you will only be - JonnyZ(SoCal) 16:42:02 09/28/12 Check your connectors, they may have swapped the O2 and your - Drunkpunk082 21:42:21 09/28/12 Re: Check your connectors, they may have swapped the O2 and your - MikeBaitZ 12:47:21 09/29/12 Yeah same thing. Connector is at the rear of the engine.. - Drunkpunk082 19:05:52 09/29/12 You mean det sensor and vtc. O2 is a 3 wire connector (n/m) - ztunerz 22:28:01 09/29/12 Re: Car will turn over & ECU flashes Code:34 - craigz96tt 09:32:31 09/30/12
Post a Followup	You cannot reply to this message because you are not logged in.