Subject	A few minor issues after pulled plenum
Posted by	tian2bing on September 24, 2012 at 11:02 AM
	This message has been viewed 207 times.
Message	1. the vacuum connector on the driver side: how is it connected? mine is loose, you can actually rotate it freely. I used RCV to seal it back, is that wrong? 2. there are 2 vtc solenoids. one with longer wire, one with shorter wire. which one should be on the driver side? are these two units identical and interchangeable? after i unseated these my memory just slipped
Follow Ups	A few minor issues after pulled plenum - tian2bing 11:02:29 09/24/12 Can't recall on the VTC but.. - Drunkpunk082 15:16:38 09/24/12 For the side of plenum threaded vacuum port fitting... - jzack 18:27:50 09/24/12 VTC solenoid with the longer wire goes on the passenger side (n/m) - Woody75 (Denver) 23:35:26 09/24/12 much obliged everyone (n/m) - tian2bing 09:14:37 09/25/12
Post a Followup	You cannot reply to this message because you are not logged in.