Subject	Re: Where in MN are you?
Posted by	Glooj on September 20, 2012 at 12:36 PM
	This message has been viewed 230 times.
In Reply To	Where in MN are you? (n/m) posted by Summeronthechain (MN) on September 20, 2012 at 07:21 AM
Message	Thanks Medallion. I cross referenced a few pictures of the balance bar from a plenum pull write up and it appears I have the bracket on correctly. I did wonder though if my three balance bar o-rings could be bad? Summeronthechain; I'm in Glenwood MN, about 15 miles south of Alexandria
Follow Ups	Boost leak test results. Very low vacuum - Glooj 23:03:00 09/19/12 Re: Boost leak test results. Very low vacuum - Medallion Man 06:18:02 09/20/12 Where in MN are you? (n/m) - Summeronthechain (MN) 07:21:21 09/20/12 Re: Where in MN are you? - Glooj 12:36:36 09/20/12 I will be at my parents place in Richmond, MN this weekend - Summeronthechain (MN) 12:00:57 09/25/12 Re: Boost leak test results. Very low vacuum - Glooj 12:58:21 09/20/12 Re: Re: Boost leak test results. Very low vacuum - Glooj 17:58:15 09/20/12 What did you use to adapt the new style injectors into - Evan_Wright (Ca) 18:14:09 09/20/12 Re: What did you use to adapt the new style injectors into - Glooj 18:43:58 09/20/12 Yes, the pcv valves are closed under boost. However, the - Evan_Wright (Ca) 19:05:27 09/20/12 Re: Re: What did you use to adapt the new style injectors into - Medallion Man 04:13:51 09/21/12 Re: What did you use to adapt the new style injectors into - Glooj 19:01:11 09/20/12 Re: Boost leak test results. Very low vacuum - craigz96tt 10:52:11 09/21/12
Post a Followup	You cannot reply to this message because you are not logged in.