Subject	There's really no reason that seal should be leaking...
Posted by	jzack on September 19, 2012 at 10:57 PM
	This message has been viewed 185 times.
In Reply To	Puzzled and Need Help!!! posted by krstull93 on September 19, 2012 at 04:41 PM
Message	however, if the mating surfaces on either the upper or lower plenum was warped -- that could explain it? Having a hard time believing a leaking gasket is the issue? Did the car just start doing this or was something else done like the plenum replaced, engine had some other type of damage, etc? What's the reason you believe that gasket has blown out (again?). PS - We aren't there, can't read your mind, etc -- so the more info. the better.
Follow Ups	Puzzled and Need Help!!! - krstull93 16:41:26 09/19/12 Are you talking about the gasket between upper and lower - Gordo 93TT Daytona 17:47:34 09/19/12 Re: Are you talking about the gasket between upper and lower - krstull93 19:59:23 09/19/12 There's really no reason that seal should be leaking... - jzack 22:57:05 09/19/12 Re: There's really no reason that seal should be leaking... - krstull93 07:23:22 09/20/12 Agreed. There is plenty of surface area to insure a seal. - Gordo 93TT Daytona 10:29:49 09/20/12 Re: Agreed. There is plenty of surface area to insure a seal. - krstull93 22:44:42 09/20/12 They fit into a milled out flat on each side of the plenum - Gordo 93TT Daytona 14:15:56 09/21/12 Generally I've found just installing all the bolts on those - jzack 19:17:26 09/21/12
Post a Followup	You cannot reply to this message because you are not logged in.