Subject	Re: Clutch safety switch: I eliminated that function by
Posted by	Gordo 93TT Daytona on September 16, 2012 at 2:25 PM
	This message has been viewed 250 times.
In Reply To	Adjustable clutch pedal stop install location? posted by DomZ32TT on September 16, 2012 at 12:27 PM
Message	disconnecting the leads it at the pedal pivot switch connector. Use a short length of wire bent in a 'U-shape" to close the circuit. Tape the exposed wire to prevent shorts, and zip tie it out of the way. Tort Attorneys please note: I grew up before this safety function was mandated. Consequently, it is first nature for me to double check the trans is in neutral before I turn the key to start. If one forgets to do this, depending on what gear your in, the car will jump forward 6-10" before you catch it. So my advice to all readers is that this is not the best shortcut for you if your were born into a world of DOT mandated safety switches. _________________________________________________
Follow Ups	Adjustable clutch pedal stop install location? - DomZ32TT 12:27:41 09/16/12 Re: Clutch safety switch: I eliminated that function by - Gordo 93TT Daytona 14:25:48 09/16/12 Re: Re: Clutch safety switch: I eliminated that function by - craigz96tt 14:37:33 09/16/12 I can't say I disagree with you. I suggested this for the - Gordo 93TT Daytona 16:33:37 09/16/12 Yep I understand I also had to hard wire one on an n/a til.. - craigz96tt 12:48:27 09/17/12 Me too. I hated that switch, but I can see potential - zellamay 15:56:47 09/16/12 Clutch Switch was mandated in 1985 along with the - Gordo 93TT Daytona 15:05:33 09/17/12
Post a Followup	You cannot reply to this message because you are not logged in.