Subject	plenum bolt strip but, ok?
Posted by	Zinprogress on September 13, 2012 at 6:53 PM
	This message has been viewed 324 times.
Message	I took my plenum off to do a gasket and vtcs and make sure everything was good and I put it back on and when I was putting the bolts on on seemed to sit good but it kept turning so I took it out and it stripped out two threads so it is sitting snug in there but when you turn it nymore it will keep turning. I know I need to do a helicoil but will it be ok and not effect anything too much for a couple months until I take it off to do fuel injectors and that? I know stupid question but I am kind of worring about. It is a twin turbo also.
Follow Ups	plenum bolt strip but, ok? - Zinprogress 18:53:05 09/13/12 Hard to believe this would cause any real issues other - jzack 21:02:29 09/13/12 Re: Hard to believe this would cause any real issues other - Zinprogress 21:36:52 09/13/12 If the damage to the threads isn't bad - why not try - jzack 22:13:54 09/13/12 Re: If the damage to the threads isn't bad - why not try - Zinprogress 10:48:17 09/14/12 I striped the plenum tube tread on - boostlv 15:50:52 09/14/12 Re: I striped the plenum tube tread on - Zinprogress 00:41:18 09/15/12 It will be fine. (n/m) - Summeronthechain (MN) 21:36:06 09/13/12 Why take the chance to not put a $2.00 helicoil in it. Safer (n/m) - craigz96tt 08:12:34 09/14/12 If its not on the end, then adjacent bolts might compensate - Gordo 93TT Daytona 12:52:55 09/16/12
Post a Followup	You cannot reply to this message because you are not logged in.