Subject	Yes with key on should be close to 12v power and hear whine
Posted by	craigz96tt on September 11, 2012 at 10:15 AM
	This message has been viewed 246 times.
In Reply To	Should I get a 12 Volt reading on the pin connector of the posted by NismoDHS on September 11, 2012 at 09:44 AM
Message	but if bad you won't get volts or whine when turned on. Same thing you pull out if changing fuel filter. More likely that's your issue rather than fuel pump was. It turns over but no fuel at all correct?
Follow Ups	Should I get a 12 Volt reading on the pin connector of the - NismoDHS 09:44:41 09/11/12 Yes with key on should be close to 12v power and hear whine - craigz96tt 10:15:21 09/11/12 Re: Looks like after hundreds of dollars later.... - NismoDHS 13:05:01 09/11/12 No the relay opens and closes a circuit for a specific amt - craigz96tt 18:43:31 09/11/12 - I think my ECU may be messed up now...here's why: - NismoDHS 11:42:09 09/12/12 ...also, just checked my ECU and it doesn't even go into - NismoDHS 14:06:50 09/12/12 Please post a follow up when repaired that's how we learn (n/m) - craigz96tt 10:51:22 09/11/12
Post a Followup	You cannot reply to this message because you are not logged in.