Subject	Re: What size hole in the restrictor from the low speed kit?
Posted by	Lowfategg on September 08, 2012 at 4:58 AM
	This message has been viewed 503 times.
In Reply To	What size hole in the restrictor from the low speed kit? (n/m) posted by craigz96tt on September 07, 2012 at 10:53 AM
Message	I tried a range of different sizes ranging from 1/8" to 3/8". I also tried adding restrictors to both hoses. I am almost 100% sure its an injector issue. Either one is leaking or jammed up.
Follow Ups	Misfire/Idle issue, Running extremely rich. - Lowfategg 14:40:56 09/06/12 Re: Misfire/Idle issue, Running extremely rich. - scottmt21 09:44:25 09/07/12 What size hole in the restrictor from the low speed kit? (n/m) - craigz96tt 10:53:35 09/07/12 Re: What size hole in the restrictor from the low speed kit? - Lowfategg 04:58:23 09/08/12 If you figure this out, make sure to post up the solution. - treese88 08:28:46 09/09/12 Re: If you figure this out, make sure to post up the solution. - Lowfategg 15:07:27 09/09/12
Post a Followup	You cannot reply to this message because you are not logged in.