Subject	Hmm...it's very possible the TDC mark on the pulley is wrong
Posted by	inf on September 06, 2012 at 2:03 PM
	This message has been viewed 189 times.
In Reply To	Re: Hmm... posted by Cjw3 on September 06, 2012 at 11:20 AM
Message	since it has an aftermarket red anodized crank pulley. I've already pulled a vacuum hose to further verify it's a lean misfire. I'm going to try retarding timing a bit to see how the misfire reacts. I guess if I do the timing belt I'll go ahead put an old pulley back on. The line on the pulley lines up with the cover pretty well...
Follow Ups	Compression and valves - inf 21:17:42 09/04/12 I would also like to add there are no codes... - inf 21:26:32 09/04/12 Re: Compression and valves - Cjw3 23:28:30 09/04/12 Re: Re: Compression and valves - Cjw3 23:43:50 09/04/12 Hmm... - inf 12:01:44 09/05/12 Re: Hmm... - Cjw3 11:20:26 09/06/12 Hmm...it's very possible the TDC mark on the pulley is wrong - inf 14:03:47 09/06/12 Well, that didn't do anything... (n/m) - inf 14:19:43 09/06/12 I know I shouldn't be celebrating, but woohoo! - inf 21:57:07 09/06/12 What's confusing me is if it's a misfire then the popping - inf 19:10:59 09/05/12 The oscillating needle going smooth is normal - BlackholeZ 03:00:46 09/05/12 Hey man - inf 12:02:08 09/05/12 hey bud - BlackholeZ 01:40:29 09/06/12
Post a Followup	You cannot reply to this message because you are not logged in.