Subject	Re: camshaft brackets
Posted by	Cjw3 on September 02, 2012 at 10:23 PM
	This message has been viewed 168 times.
In Reply To	camshaft brackets posted by inf on September 02, 2012 at 09:28 PM
Message	Must go back in the SAME place.. as I remember, there are some casting marks ( Casting Stamps ? ) that will help tell position .. I had a few 'Unknown Caps' that were not well marked on my replacement heads.. I pulled the Lifters and assembled the Cams in the heads.. if the Cam Journal Cap is in the wrong spot, the cam will not turn as you try to tighten the cap .. keep moving the caps around till you can get all the caps tight, and the cams still move FREELY.. NO DRAG.. if they drag, its not right.. should turn hand free even when the Caps are Torqued Up..
Follow Ups	camshaft brackets - inf 21:28:48 09/02/12 Re: camshaft brackets - Cjw3 22:23:47 09/02/12 cool - inf 13:54:52 09/03/12 They should be marked - Broke_as_**** 17:34:05 09/03/12 ya, read that through and through.. - inf 20:19:50 09/03/12 oh ya...these heads are off another engine - inf 20:21:47 09/03/12
Post a Followup	You cannot reply to this message because you are not logged in.