Subject	Consult says Code 11 - Camshaft Angle Sensor Error
Posted by	Mikester(Seattle) on August 30, 2012 at 8:54 PM
	This message has been viewed 166 times.
In Reply To	After work, I tried starting and it gave an abrupt *thud*.. posted by Mikester(Seattle) on August 30, 2012 at 08:30 PM
Message	Again when I tried to start it, same issue. A hard thud on first turn, then turning the key again after a few seconds hesitated for about 5 seconds then fired. LOTS of burnt/exhausted synthetic oil smell too.
Follow Ups	Syn. 10W-30 oil change, now rough idle and blue smoke - Mikester(Seattle) 12:15:23 08/30/12 Note: Ticking was due to being very low on oil. (n/m) - Mikester(Seattle) 12:25:28 08/30/12 Re: Syn. 10W-30 oil change, now rough idle and blue smoke - MaxxAction 15:39:18 08/30/12 After work, I tried starting and it gave an abrupt *thud*.. - Mikester(Seattle) 20:30:28 08/30/12 Consult says Code 11 - Camshaft Angle Sensor Error - Mikester(Seattle) 20:54:12 08/30/12 Well, if you have CAS error I would check the wiring and - JonnyZ(SoCal) 00:03:26 08/31/12 Re: Syn. 10W-30 oil change, now rough idle and blue smoke - MaxxAction 08:55:40 08/31/12 pull the plugs and see if it spins over. (n/m) - Gordo 93TT Daytona 16:35:45 08/31/12
Post a Followup	You cannot reply to this message because you are not logged in.