Subject	anyone know the thread pitch/size
Posted by	Luminar on August 26, 2012 at 8:26 PM
	This message has been viewed 127 times.
Message	of the nuts that bolt onto the front struts? I am trying to further clean up my engine compartment. Also a side note: does anyone see any issue with using a 4mm washer to ensure an acorn nut clears the whole shaft? or is that a bad idea?
Follow Ups	anyone know the thread pitch/size - Luminar 20:26:42 08/26/12 Re: anyone know the thread pitch/size - MaxxAction 09:14:50 08/27/12
Post a Followup	You cannot reply to this message because you are not logged in.